CLI Reference Guide

320 DHCP Layer 2 Relay Commands
Syntax
show dhcp l2relay vlan vlan-range
• vlan-range — Show information for the specified VLAN range. A range may be a
single VLAN ID or two VLAN IDs separated by a single dash with no embedded
spaces.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
There are no user guidelines for this command.
Example
console#show dhcp l2relay vlan 100
DHCP L2 Relay is Enabled.
DHCP L2 Relay is enabled on the following VLANs:
100
show dhcp l2relay circuit-id vlan
Use the show dhcp l2relay circuit-id vlan command in Privileged EXEC
mode to display whether DHCP L2 Relay is globally enabled and whether the
DHCP Circuit-ID option is enabled on the specified VLAN or VLAN range.
Syntax
show dhcp l2relay circuit-id vlan vlan-range
• vlan-range — Show information for the specified VLAN range. A range may be a
single VLAN ID or two VLAN IDs separated by a single dash with no embedded
spaces.
Default Configuration
This command has no default configuration.
2CSNXXX_SWUM200.book Page 320 Tuesday, December 10, 2013 1:22 PM