CLI Reference Guide

CDP Interoperability Commands 309

Example

console#show isdp neighbors

Capability Codes: R - Router, T - Trans Bridge, B - Source Route, S - Switch,

H - Host, I - IGMP, r - Repeater

Device ID Intf Hold Cap. Platform Port ID

------------- ----- ---- ---------------

Switch1/0/1 165 RI cisco WS-C4948 GigabitEthernet1/1

console#show isdp neighbors detail

Device ID Switch

Address(es):

IP Address: 172.20.1.18

Capability Router IGMP

Platform cisco WS-C4948

Interface 1/0/1

Port ID GigabitEthernet1/1

Holdtime 162

Advertisement Version 2

Entry last changed time 0 days 00:55:20

Version :

Cisco IOS Software, Catalyst 4000 L3 Switch Software (cat4000-I9K91S-M),

Version 12.2(25)EWA9, RELEASE SOFTWARE (fc3)

Technical Support: http://www.cisco.com/techsupport

Compiled Wed 21-Mar-07 12:20 by tinhuang

show isdp traffic

The show isdp traffic command displays ISDP statistics.

Syntax

show isdp traffic

Default Configuration

There is no default configuration for this command.

Command Mode

Privileged EXEC mode, Configuration mode and all Configuration submodes

2CSNXXX_SWUM200.book Page 309 Tuesday, December 10, 2013 1:22 PM