CLI Reference Guide

304 CDP Interoperability Commands
console(config)#interface gigabitethernet 1/0/1
console(config-if-Gi1/0/1)#isdp enable
isdp holdtime
The isdp holdtime command configures the hold time for ISDP packets that
the switch transmits. The hold time specifies how long a receiving device
should store information sent in the ISDP packet before discarding it. The
range is given in seconds. Use the no form of this command to reset the
holdtime to the default.
Syntax
isdp holdtime time
no isdp holdtime
• time —The time in seconds (range 10–255 seconds).
Default Configuration
The default holdtime is 180 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets isdp holdtime to 40 seconds.
console(config)#isdp holdtime 40
isdp timer
The isdp timer command sets period of time between sending new ISDP
packets. The range is given in seconds. Use the “no” form of this command to
reset the timer to the default.
2CSNXXX_SWUM200.book Page 304 Tuesday, December 10, 2013 1:22 PM