CLI Reference Guide

298 Auto-VoIP Commands
show switchport voice
Use the show switchport voice command to show the status of Auto-VoIP on
an interface or all interfaces.
Syntax
show switchport voice [gigabitethernet unit/slot/port| port-channel port-
channel-number
| tengigabitethernet unit/slot/port | fortygigabitethernet
unit/slot/port]
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
There are no user guidelines for this command.
Examples
The following example shows command output when a port is not specified:
console#show switchport voice
Interface Auto VoIP Mode Traffic Class
--------- -------------- -------------
Gi1/0/1 Disabled 6
Gi1/0/2 Disabled 6
Gi1/0/3 Disabled 6
Gi1/0/4 Disabled 6
Gi1/0/5 Disabled 6
Gi1/0/6 Disabled 6
Gi1/0/7 Disabled 6
Gi1/0/8 Disabled 6
Gi1/0/9 Disabled 6
Gi1/0/10 Disabled 6
Gi1/0/11 Disabled 6
Gi1/0/12 Disabled 6
Gi1/0/13 Disabled 6
Gi1/0/14 Disabled 6
Gi1/0/15 Disabled 6
2CSNXXX_SWUM200.book Page 298 Tuesday, December 10, 2013 1:22 PM