CLI Reference Guide

274 ACL Commands
show service-acl interface
This command displays the status of LLPF rules configured on a particular
port or on all the ports.
Syntax
show service-acl interface { interface-id | all}
• interface-id—Any physical or logical interface. See Interface Naming
Conventions
for interface representation.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
This command has no user guidelines.
Example
console#show service-acl interface gi1/0/1
Block CDP................................ Enable
Block VTP.................................Enable
Block DTP..................................Enable
Block UDLD................................ Enable
Block PAGP.................................Enable
Block SSTP................................ Enable
Block All................................. Enable
show access-lists interface
Use the show access-lists interface command in Privileged EXEC mode to
display interface ACLs.
Syntax
show access-lists interface interface-id {in | out} | control-plane
• interface-id — The interface identifier (physical, port-channel, or VLAN).
2CSNXXX_SWUM200.book Page 274 Tuesday, December 10, 2013 1:22 PM