CLI Reference Guide

Time Ranges Commands 1751
82
Time Ranges Commands
Dell Networking N2000/N3000/N4000 Series Switches
Time ranges are used with time-based ACLs to restrict their application due
to specific time slots.
This chapter explains the following commands:
time-range
Use the time-range command in Global Configuration mode to globally
enable or disable the event notification service of the time range component.
If disabled, ACLs using time ranges are not started.
Use the optional
name parameter to create a time range consisting of one
absolute time entry and/or one or more periodic time entries. If a time range
by this name already exists, this command enters Time-Range Configuration
mode to allow updating the time range entries.
Use the no form of the command to disable the event notifciation service.
Use the no form of this command with the optional
name parameter to delete
a time-range identified by
name .
Syntax
time-range [ name ]
no time-range [
name ]
• name —A case-sensitive alphanumeric string from 1 to 31 characters
uniquely identifying the time range. An alpha-numeric string is defined as
consisting of only alphabetic, numeric, dash, underscore, or space
characters.
Default Configuration
Time range event notification is enabled by default.
time-range periodic
absolute show time-range
2CSNXXX_SWUM200.book Page 1751 Tuesday, December 10, 2013 1:22 PM