CLI Reference Guide

Telnet Server Commands 1747
Commands in this Chapter
This chapter explains the following commands:
ip telnet server disable
The ip telnet server disable command is used to enable/disable the Telnet
service on the switch.
Syntax
ip telnet server disable
no ip telnet server disable
Command Mode
Global Configuration
User Guidelines
No specific guidelines.
Default Value
This feature is enabled by default.
Example
console#configure
console(config)#ip telnet server disable
console(config)# no ip telnet server disable
ip telnet port
The ip telnet port command is used to configure the Telnet TCP port
number on which the switch listens for Telnet connections.
ip telnet server disable show ip telnet
ip telnet port
–
2CSNXXX_SWUM200.book Page 1747 Tuesday, December 10, 2013 1:22 PM