CLI Reference Guide

System Management Commands 1741
• maxTtl — The largest TTL value that can be used (Range:1–255). The default is
30. This must be larger or equal to the value specified in initTtl.
• maxFail — Terminate the traceroute after failing to receive a response for this
number of consecutive probes (Range: 0–255).
• interval — The timeout period. If a response is not received within this period of
time, then traceroute considers that probe a failure (printing *) and sends the
next probe. If traceroute does receive a response to a probe, then it sends the
next probe immediately. (Range: 1–60 seconds). The default is 3.
• count — The number of probes to be sent at each TTL level (Range:1–10).
• port — The destination UDP port of the probe. This should be an unused port on
the remote destination system (Range: 1–65535).
• size — The size, in bytes, of the payload of the Echo Requests sent (Range:
0–
39936 bytes). The default is 0.
• src-ip-address — The IPv4 source address to use in the ICMP echo request
packets.
• vlan — The source VLAN over which to send the echo request.
• loop-id — A configured loopback ID
Default Configuration
The default count is 3 probes.
The default interval is 3 seconds.
The default size is 0 data bytes.
The default port is 33434.
The default initTtl is 1 hop.
The default maxTtl is 30 hops.
The default maxFail is 5 probes.
Command Mode
Privileged EXEC mode.
2CSNXXX_SWUM200.book Page 1741 Tuesday, December 10, 2013 1:22 PM