CLI Reference Guide

System Management Commands 1709
show slot
Use the show slot command in User EXEC mode to display information
about all the slots in the system or for a specific slot.
Syntax
show slot [ slot/port ]
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Configuration mode and all Configuration submodes
User Guidelines
The following table explains the output parameters.
If you supply a value for slot/port, the following additional information
appears as shown in the table below.
Parameter Description
Slot The slot identifier in a slot/port format.
Slot Status The slot is empty, full, or has encountered
an error.
Admin State The slot administrative mode is enabled
or disabled.
Power State The slot power mode is enabled or
disabled.
Configured Card Model Identifier The model identifier of the card
preconfigured in the slot. Model identifier
is a 32-character field used to identify a
card.
Pluggable Cards are pluggable or non-pluggable in
the slot.
2CSNXXX_SWUM200.book Page 1709 Tuesday, December 10, 2013 1:22 PM