CLI Reference Guide

1690 System Management Commands
• loopbackaddress — The source address from the loopback port index.
•
vlanid — The VLAN IPv4 or IPv6 address in the transmitted packets.
•
tunnelid — The tunnel interface IPv4 or IPv6 address in the transmitted
packets.
•
out-of-band — The out-of-band interface IPv4 or IPv6 address in the
transmitted packets.
Default Configuration
The default count is 4.
The default interval is 3 seconds.
The default size is 0 data bytes.
It is not possible to ping from a specific interface when a VLAN is specified as
the source of the ping. The system selects the first available interface in the
VLAN from which to send the ping packets.
Command Mode
User EXEC mode, Privileged EXEC mode
User Guidelines
The local VRRP IP address is not pingable.
Examples
The following example sends an IPv4 ICMP Echo requests from VLAN 3 to
10.1.1.3
console#ping 10.1.1.3 source vlan 3
quit
Use this command to disconnect the serial connection to the remote unit on
the stack member.
Syntax
quit
2CSNXXX_SWUM200.book Page 1690 Tuesday, December 10, 2013 1:22 PM