CLI Reference Guide

System Management Commands 1685
User Guidelines
The LED will blink green until it times out. The user may select a new time
value while the LED is blinking. The last value selected takes effect
immediately. The locate command does not persist across reboots. This
command is not supported on Dell Networking N2000/N3000 Series series
switches.
Example
console# locate switch 1 time 555
login-banner
Use the login-banner command to enable login banner on the console, telnet
or SSH connection. To disable, use the no form of the command.
Syntax
login-banner
no login-banner
• MESSAGE — Quoted text
Default Configuration
This command has no default configuration.
Command Mode
Line Configuration
User Guidelines
This command has no user guidelines.
Example
console(config-telnet)# no login-banner
logout
Use this command to disconnect the serial connection to the remote unit on
the stack member.
2CSNXXX_SWUM200.book Page 1685 Tuesday, December 10, 2013 1:22 PM