CLI Reference Guide

1684 System Management Commands
Syntax
load-interval time
no load-interval
• time — The number of seconds after which interface utilization is measured
periodically. The time has to be a multiple of 30. (Range 30-600 seconds)
Default Configuration
The default interval is 300 seconds.
Command Modes
Interface Configuration mode, Interface Range Configuration mode, Port
Channel Configuration mode, Port Channel Range Configuration mode.
User Guidelines
This command has no user guidelines.
Example
console(config-if-Gi1/0/1)#load-interval 150
locate
Use the locate command to locate a switch by LED blinking.
Syntax
locate [switch unit ] [time time ]
•switch unit —If multiple devices are stacked, you can choose which switch
to identify.
•
time time —LED blinking duration in seconds. Range 1-3600 seconds.
Default Configuration
Default value is 20 seconds.
Command Mode
Privileged EXEC
2CSNXXX_SWUM200.book Page 1684 Tuesday, December 10, 2013 1:22 PM