CLI Reference Guide

1680 System Management Commands
User Guidelines
This command is available in privileged exec mode on the master unit serial
port and from the Unit prompt on member unit serial ports. The user need
not be currently connected over the serial port to connect to another unit.
The stack member being connected to must be up and running and
connected as part of the stack.
Example
Example 1:
To disconnect a remote session to a stack member established from the stack
manager.
Stack-Master#connect 2
Remote session started. Type "exit" to exit the session.
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>exit
Stack-Master#
Example 2:
To disconnect a remote session to the stack master established from a stack
member.
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>connect 2
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>connect 1
Stack-Master#
Stack-Master#exit
Stack-Master>exit
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>
hardware profile portmode
Use the hardware profile portmode command in Interface Configuration
mode to configure a 40G port in 4x10G mode or 1x40G mode.
2CSNXXX_SWUM200.book Page 1680 Tuesday, December 10, 2013 1:22 PM