CLI Reference Guide

Serviceability Tracing Packet Commands 1591
console(config)#exception protocol usb
console(config)#do dir usb
Filename Filesize Modification Time
. 16384 01/01/1970 00:00:00
.. 0 06/24/2013 17:14:30
test.bin 11 01/01/1980 00:00:00
Total Size: 1002160128
Bytes Used: 16384
Bytes Free: 1002143744
exception switch-chip-register
Use the exception switch-chip-register command to enable dumping the
switch chip registers in case of an exception. The register dump is taken only
for the master unit and not for the stack member units. Use the no form of
the command to disable dumping of the switch-chip registers.
Syntax
exception switch-chip-register
no exception switch-chip-register
Default Configuration
By default, switch register dumps are disabled.
Command Modes
Global Configuration mode
User Guidelines
This option should only be used under the direction of Dell support
personnel.
Switch registers are captured to the local file system.
show debugging
Use the show debugging command to display packet tracing configurations.
2CSNXXX_SWUM200.book Page 1591 Tuesday, December 10, 2013 1:22 PM