CLI Reference Guide

Serviceability Tracing Packet Commands 1587
debug vrrp
Use the debug vrrp command in Privileged EXEC mode to enable VRRP
debug protocol messages. Use the no form of this command to disable VRRP
debug protocol messages.
Syntax
debug vrrp all
no debug vrrp all
Default Configuration
The display of VRRP traces is disabled by default.
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
exception core-file
Use the exception core-file command to configure the core dump file name.
Use the no form of the command the reset the core file name to the default.
Syntax
exception core-file file-name [hostname [time-stamp] | time-stamp
[
hostname ]]
no exception core-file
• file-name — The file name. The maximum length is 15 characters.
Embedded blanks may not be allowed by the host file system (for example,
TFTP server) and are not recommended.
•
hostname — Includes the switch host name in the core file name. If not
configured, uses the switch MAC address in the core file name.
•
time-stamp —Includes the switch TOD in the core file name.
2CSNXXX_SWUM200.book Page 1587 Tuesday, December 10, 2013 1:22 PM