CLI Reference Guide

1562 SDM Templates Commands
The following table explains the output parameters.
Examples
This example shows the current SDM template. The user has not changed
the next active SDM template.
console# show sdm prefer
The current template is the Dual IPv4 and IPv6 template.
ARP Entries..................................6144
IPv4 Unicast Routes..........................8160
IPv6 NDP Entries.............................2560
IPv6 Unicast Routes..........................4096
ECMP Next Hops...............................4
IPv4 Multicast Routes........................1536
Message Type Message Description
Successful
Completion
Message
Changes to the running SDM preferences have been stored, but
cannot take effect until the next reload.
Use the
show sdm prefer command to see what SDM preference
is currently active.
Error Completion
Message
None
Parameter Description
ARP Entries The maximum number of entries in the IPv4 Address
Resolution Protocol (ARP) cache for routing interfaces.
IPv4 Unicast Routes The maximum number of IPv4 unicast forwarding table entries.
IPv6 NDP Entries The maximum number of IPv6 Neighbor Discovery Protocol
(NDP) cache entries.
IPv6 Unicast Routes The maximum number of IPv6 unicast forwarding table entries.
ECMP Next Hops The maximum number of next hops that can be installed in the
IPv4 and IPv6 unicast forwarding tables.
IPv4 Multicast
Routes
The maximum number of IPv4 multicast forwarding table
entries.
IPv6 Multicast
Routes
The maximum number of IPv6 multicast forwarding table
entries.
2CSNXXX_SWUM200.book Page 1562 Tuesday, December 10, 2013 1:22 PM