CLI Reference Guide

1534 Power Over Ethernet Commands
no power inline priority
Command Mode
Interface Configuration (Ethernet).
User Guidelines
Priority is always enabled for all ports. If all ports have equal priority in an
overload condition, the switch will shut down the lowest numbered ports
first.
Default Value
Low
Examples
console(config)#interface gigabitethernet 1/0/1
console(config-if-Gi1/0/1)# power inline priority high
power inline reset
Use the power inline reset command to reset the port.
Syntax
power inline reset
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration
User Guidelines
This command is useful if the port is stuck in an Error state. Power to the
powered devices may be interrupted.
2CSNXXX_SWUM200.book Page 1534 Tuesday, December 10, 2013 1:22 PM