CLI Reference Guide

Power Over Ethernet Commands 1529
User Guidelines
User defined limits are only operational if the power management mode is
configured as static. By default, the power management mode is dynamic. If
the operator attempts to set the limit to user defined and the power
management mode is not configured as static, a warning is issued and the
command has no effect.
power inline management
Use the power inline management command in Global Configuration mode
to set the power management type. This command is used along with the
power inline priority command on page 1533. Use the no form of this
command to set the management mode to the default.
Syntax
power inline management {dynamic | static | class}
no power inline management
• dynamic —Dynamic power management
•
static —Static power management
•
class —Class-based power management
Default Configuration
Default management is dynamic.
Command Mode
Global Configuration
User Guidelines
Static and dynamic modes differ in how the available power is calculated:
Static Power Management
Available Power = Power limit of the Sources – Total Configured power
Where Total Configured Power is calculated as sum of the configured power
limit configured on the port.
2CSNXXX_SWUM200.book Page 1529 Tuesday, December 10, 2013 1:22 PM