CLI Reference Guide

Power Over Ethernet Commands 1527
Default Value
auto
Examples
console(config)#interface gigabitethernet 1/0/1
console(config-if-Gi1/0/1)# power inline auto
power inline detection
Use the power inline detection command in Interface Configuration mode
to configure the detection type that tells which types of PD’s will be detected
and powered by the switch. Use the no form of this command to set the
detection type to the default.
Syntax
power inline detection {dot3af+legacy | dot3af}
no power inline detection
• dot3af+legacy —IEEE 802.3af 4-point detection followed by legacy
capacitive detection.
•
dot3af —IEEE 802.3af 4-point detection only. Legacy capacitive detection
is disabled.
Default Value
The default value is dot3af+legacy.
Command Mode
Global Configuration
User Guidelines
This command has no user guidelines.
power inline high-power
Use this command to enable high power mode. Use the no form of this
command to disable high power mode. In high power mode, the switch (PSE)
negotiates the power budget with the powered device (PD) via LLDP.
2CSNXXX_SWUM200.book Page 1527 Tuesday, December 10, 2013 1:22 PM