CLI Reference Guide

1526 Power Over Ethernet Commands
Commands in this Chapter
This chapter explains the following commands:
power inline
The power inline command enables/disables the ability of the port to deliver
power.
Syntax
power inline { auto | never }
no power inline
• auto — Enables device discovery and, if a device is found using the
method specified by the power inline detection setting,
supplies power to
the device.
•
never — Disables the device discovery protocol and stops supplying power
to the device.
Command Mode
Interface Configuration (Ethernet).
User Guidelines
Auto enables the switch to negotiate with the powered device via LLDP to
learn the device's desired power draw. The power inline detection parameter
should be set to class.
power inline power inline priority
power inline detection power inline reset
power inline high-power power inline usage-threshold
power inline limit clear power inline statistics
power inline management show power inline
power inline powered-device show power inline firmware-version
2CSNXXX_SWUM200.book Page 1526 Tuesday, December 10, 2013 1:22 PM