CLI Reference Guide

Password Management Commands 1511
Default Configuration
The default value is 1.
Command Mode
Global Configuration
User Guidelines
This command has no effect unless enabled by the passwords strength
minimum character-classes command. This limit is not enforced unless the
passwords strength minimum character-classes command is configured with
a value greater than 0.
Example
console(config)#passwords strength minimum lowercase-letters 6
passwords strength minimum numeric-
characters
Use this command to enforce a minimum number of numeric numbers that a
password should contain. The valid range is 0–16. The default is 1. A
minimum of 0 means no restriction on that set of characters. Use the no form
of this command to reset the minimum numeric characters to the default
value.
Syntax
passwords strength minimum numeric–characters 0–16
no passwords strength minimum numeric–characters
Default Configuration
The default value is 1.
Command Mode
Global Configuration
2CSNXXX_SWUM200.book Page 1511 Tuesday, December 10, 2013 1:22 PM