CLI Reference Guide

Captive Portal Commands 1423
show captive-portal configuration status
Use the show captive-portal configuration status command to display
information about all configured captive portal configurations or about a
specific captive portal configuration.
Syntax
show captive-portal configuration [ cp-id ] status
• cp-id —Captive Portal ID.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
There are no user guidelines for this command.
Example
console#show captive-portal configuration status
CP ID CP Name Mode Protocol Verification
----- --------------- -------- -------- ------------
1 cp1 Enable https Guest
2 cp2 Enable http Local
3 cp3 Disable https Guest
console#show captive-portal configuration 1 status
CP ID.......................................... 1
CP Name........................................ cp1
Mode........................................... Enabled
Protocol Mode.................................. https
Verification Mode.............................. Guest
Group Name..................................... group123
Redirect URL Mode.............................. Enabled
Redirect URL................................... www.cnn.com
Session Timeout (seconds)...................... 86400
2CSNXXX_SWUM200.book Page 1423 Tuesday, December 10, 2013 1:22 PM