CLI Reference Guide

Command Groups 142
ip pim rp-candidate Configures the router to advertise itself to the
bootstrap router (BSR) as a PIM candidate
rendezvous point (RP) for a specific multicast
group range.
IC
ip pim sparse-mode Administratively configures PIM sparse mode
for IP multicast routing.
GC
ip pim ssm Administratively configures PIM Source
Specific Multicast (SSM) range of addresses for
IP multicast routing.
GC
show ip multicast Displays the system-wide multicast
information.
PE
show ip pim boundary Displays the system-wide multicast
information.
PE
show ip multicast interface Displays the multicast information for the
specified interface.
PE
show ip mroute Displays a summary or all the details of the
multicast table.
PE
show ip mroute group Displays the multicast configuration settings of
entries in the multicast mroute table.
PE
show ip mroute source Displays the multicast configuration settings of
entries in the multicast mroute table.
PE
show ip mroute static Displays all the static routes configured in the
static mcast table.
PE
show ip pim bsr-router Displays the bootstrap router (BSR)
information.
PE
show ip pim interface Displays PIM interface status parameters. If no
interface is specified, the command displays the
status parameters of all PIM-enabled interfaces.
UE or
PE
show ip pim neighbor Displays PIM neighbors discovered by PIMv2
Hello messages. If no interface is specified, the
command displays the neighbors discovered on
all PIM-enabled interfaces.
UE or
PE
show ip pim rp hash Displays the rendezvous point (RP) selected for
the specified group address.
UE or
PE
Command Description Mode
a
2CSNXXX_SWUM200.book Page 142 Tuesday, December 10, 2013 1:22 PM