CLI Reference Guide

Virtual Router Redundancy Protocol Commands 1383
Syntax
show ip vrrp interface interface-id vrid
• interface-id — Any valid routing interface. See Interface Naming Conventions for
interface representation.
• vrid —The virtual router identifier. (Range: 1-255)
Default Configuration
The command has no default configuration.
Command Mode
User EXEC, Privileged EXEC mode, Configuration mode and all
Configuration submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays all configuration information about the
VLAN 15 virtual router.
console#show ip vrrp interface vlan2 1
Primary IP Address........................... 10.10.10.1
VMAC Address............................. 00:00:5E:00:01:01
Authentication Type............................ None
Priority....................................... 100
Configured Priority............................ 100
Advertisement Interval (secs).................. 1
Pre-empt Mode.................................. Enable
Administrative Mode............................ Disable
Accept Mode.................................... Enable
State.......................................... Initialized
Track Interface State Decrement Priority
--------------- ------------- ------------
No interfaces are tracked for this vrid and interface combination.
Track Route(pfx/len) Reachable Decrement Priority
--------------- ------------- ------------
No routes are tracked for this vrid and interface combination.
2CSNXXX_SWUM200.book Page 1383 Tuesday, December 10, 2013 1:22 PM