CLI Reference Guide

Virtual Router Redundancy Protocol Commands 1373
Syntax
vrrp group timers advertise interval
no vrrp group timers advertise interval
• group — The virtual router identifier. (Range: 1-255)
•
interval — The frequency at which an interface on the specified virtual
router sends a virtual router advertisement. (Range: 1-255 seconds)
Default Configuration
Interval has a default value of 1.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the frequency at which the VLAN 15 virtual
router 5 sends a virtual router advertisement.
console(config-if-vlan15)#vrrp 5 timers advertise 10
vrrp timers learn
Use the vrrp timers learn command in Interface Configuration mode to
configure the router, when it is acting as backup virtual router for a Virtual
Router Redundancy Protocol (VRRP) group, to learn the advertisement
interval used by the master virtual router. Use the no form of the command to
prevent the router from learning the advertisement interval from the master
virtual router.
Syntax
vrrp group timers learn
no vrrp
group timers learn
• group — The virtual router identifier. (Range: 1-255)
2CSNXXX_SWUM200.book Page 1373 Tuesday, December 10, 2013 1:22 PM