CLI Reference Guide

Command Groups 136
IP Routing
Command Description Mode
a
encapsulation Configures the link layer encapsulation type for
the packet.
IC
ip address Configures an IP address on an interface. IC
ip netdirbcast E nables the forwarding of network-directed
broadcasts.
IC
ip policy route-map Applies a route map on an interface. IC
ip route Configures a static route. Use the no form of
the command to delete the static route.
GC
ip route default Configures the default route. Use the no form
of the command to delete the default route.
GC
ip route distance Sets the default distance (preference) for static
routes.
GC
ip routing Globally enables IPv4 routing on the router. GC
match length Configures packet length matching criteria for a
route map.
RM
match mac-list Configures MAC ACL match criteria for a route
map.
RM
route-map Creates a policy based route map. GC
match ip address Specify IP address match criteria for a route
map.
RM
set interface null0 Routes packets to interface null 0. RM
set ip default next-hop Sets a list of default next-hop IP addresses
to be used if
no explicit route for the packet’s
destination address appears in the routing table.
RM
set ip next-hop Specifies the adjacent next-hop router in the
path toward the destination to which the
packets should be forwarded.
RM
set ip precedence Sets the IP precedence bits in the IP packet
header.
RM
show ip brief Displays all the summary information of the IP. PE
2CSNXXX_SWUM200.book Page 136 Tuesday, December 10, 2013 1:22 PM