CLI Reference Guide

1330 OSPFv3 Commands
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF stub table.
console#show ipv6 ospf stub table
AreaId TypeofService Metric Val Import SummaryLSA
------------ ------------- ---------- -----------------
0.0.0.10 Normal 1 Enable
show ipv6 ospf virtual-links
Use the show ipv6 ospf virtual-links command in Privileged EXEC mode to
display the OSPF Virtual Interface information for a specific area and
neighbor or for all areas in the system.
Syntax
show ipv6 ospf virtual-link [ area-id neighbor-id | brief]
• area-id — Identifies the OSPF area whose virtual interface information is
being displayed.
•
neighbor-id — Router ID of neighbor.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC mode, Configuration mode and all
Configuration submodes
2CSNXXX_SWUM200.book Page 1330 Tuesday, December 10, 2013 1:22 PM