CLI Reference Guide

OSPFv3 Commands 1289
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example creates the OSPF virtual interface for area 1 and its
neighbor router.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 virtual-link 2
The following example configures a 20-second dead interval, a hello interval
of 20 seconds, a retransmit interval of 20 seconds, and a 20-second transmit
delay for the OSPF virtual interface on the virtual interface identified by area
1 and its neighbor.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 virtual-link 2 dead-interval 20 hello-interval 20
retransmit-interval 20 transmit-delay 20
area virtual-link dead-interval
Use the area virtual-link dead-interval command in Router OSPFv3
Configuration mode to configure the dead interval for the OSPF virtual
interface on the virtual interface identified by
areaid and neighbor .
Syntax
area areaid virtual-link neighbor dead-interval seconds
no area areaid virtual-link neighbor dead-interval
• areaid — Valid OSPFv3 area identifier.
•
neighbor — Router ID of neighbor.
•
seconds — Dead interval. (Range: 1-65535)
Default Configuration
40 is the default value for seconds .
2CSNXXX_SWUM200.book Page 1289 Tuesday, December 10, 2013 1:22 PM