CLI Reference Guide

OSPF Commands 1263
Syntax
show ip ospf neighbor [ interface-type interface-number ] [ neighbor-id ]
• interface-type —Interface type – only supported type is vlan.
•
interface-number —A valid interface number.
•
neighbor-id —Valid IP address of the neighbor.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC modes, Configuration mode and all
Configuration submodes
User Guidelines
The following information is output.
Field Description
Interface The name of the interface on which the adjacency is formed.
Neighbor IP Address The IPv4 address on the neighbor's interface used to form the
adjacency.
Interface Index The SNMP interface index.
Area Id The OSPF area in which the adjacency is formed.
Options The options advertised by the neighbor.
Router Priority The router priority advertised by the neighbor.
Dead timer The number of seconds until the dead timer expires.
Up Time How long this adjacency has been in FULL state.
State The current state of the adjacency.
Events Incremented for the following events:
• A DD is received from the neighbor with an MTU mismatch.
• The neighbor sent an ACK for an LSA not on the neighbor's
retransmit list.
• The state of the adjacency changed.
2CSNXXX_SWUM200.book Page 1263 Tuesday, December 10, 2013 1:22 PM