CLI Reference Guide

OSPF Commands 1243
Syntax
redistribute protocol [metric metric-value] [metric-type type-value] [tag
tag-value] [subnets]
no redistribute protocol [metric] [metric-type] [tag] [subnets]
• protocol —One of the following:
– rip - Specifies RIP as the source protocol.
– static - Specifies that the source is a static route.
– connected - Specifies that the source is a directly connected route.
•
static —Specifies that the source is a static route.
•
connected —Specifies that the source is a directly connected route.
•
metric-value —Specifies the metric to use when redistributing the route.
(Range: 0–16777214)
•
type-value —One of the following:
– Type 1 external route.
– Type 2 external route.
•
tag-value —Value attached to each external route, which might be used to
communicate information between ASBRs. (Range: 0–4294967295)
•
subnets —Specifies whether to redistribute the routes to subnets.
Default Configuration
0 is the tag-value default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures OSPF protocol to allow redistribution of
routes from the specified source protocol/routers.
2CSNXXX_SWUM200.book Page 1243 Tuesday, December 10, 2013 1:22 PM