CLI Reference Guide

1234 OSPF Commands
Syntax
log-adjacency-changes [detail]
no log-adjacency-changes [detail]
• detail —(Optional) When this keyword is specified, all adjacency state
changes are logged. Otherwise, OSPF only logs transitions to FULL state
and when a backwards transition occurs.
Default Configuration
Adjacency changes are not logged by default.
Command Mode
OSPFv2 Router Configuration mode
User Guidelines
State changes are logged with INFORMATIONAL severity.
max-metric router-lsa
Use the max-metric router-lsa command in router OSPF Global
Configuration mode to configure OSPF to enable stub router mode.
To disable stub router mode, use the no max-metric router-lsa command in
OSPFv2 Global Router Configuration mode.
Syntax
max-metric router-lsa [on-startup seconds ] [summary-lsa { metric }]
no max-metric router-lsa [on-startup] [summary-lsa]
• on-startup —(Optional) OSPF starts in stub router mode after a reboot.
•
seconds —(Required if on-startup) The number of seconds that OSPF
remains in stub router mode after a reboot. The range is 5 to 86,400
seconds. There is no default value.
•
summary-lsa —(Optional) Set the metric in type 3 and 4 summary LSAs to
LsInfinity (0xFFFFFF).
•
metric —(Optional) Metric to send in summary LSAs when in stub router
mode. Range is 1 to 16,777,215. Default is 16,711,680 (0xFF0000).
2CSNXXX_SWUM200.book Page 1234 Tuesday, December 10, 2013 1:22 PM