CLI Reference Guide

OSPF Commands 1233
console(config-if-vlan1)#ip ospf retransmit-interval 50
ip ospf transmit-delay
Use the ip ospf transmit-delay command in Interface Configuration mode to
set the OSPF Transit Delay for the specified interface. Use the no form of the
command to return the delay to the default value.
Syntax
ip ospf transmit-delay seconds
no ip ospf transmit-delay
• seconds — Sets the estimated number of seconds it takes to transmit a link
state update packet over this interface. (Range: 1–3600 seconds)
Default Configuration
1 is the default number of seconds.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF Transit Delay for VLAN 15 at 20
seconds.
console(config-if-vlan1)#ip ospf transmit-delay 20
log adjacency-changes
Use the log adjacency-changes command in OSPFv2 Router Configuration
mode to enable logging of OSPFv2 neighbor state changes.
Use the no form of the command to disable state change logging.
2CSNXXX_SWUM200.book Page 1233 Tuesday, December 10, 2013 1:22 PM