CLI Reference Guide

OSPF Commands 1227
Default Configuration
10 is the default link-state metric configuration.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the cost on the OSPF interface at 5.
console(config-if-vlan1)#ip ospf cost 5
ip ospf database-filter all out
Use the ip ospf database-filter all out command in Interface Configuration
mode to prevent flooding of OSPF LSAs on an interface.
Use the no form of the command to enable flooding of LSAs on an interface.
Syntax
ip ospf database-filter all out
no ip ospf database-filter all out
Default Configuration
By default, LSAs are flooded on all interfaces in a routed VLAN.
Command Mode
Interface Configuration mode
User Guidelines
This command is only applicable to OSPFv2 routing configurations.
2CSNXXX_SWUM200.book Page 1227 Tuesday, December 10, 2013 1:22 PM