CLI Reference Guide

1222 OSPF Commands
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example specifies the access list to filter routes received from
the RIP source protocol.
console(config-router)#distribute-list ACL40 out rip
enable
This command has been deprecated. Use the enable command in Router
OSPF Configuration mode to reset the default administrative mode of OSPF
in the router (active). OSPF is now globally enabled using the
router ospf
command. Use the no form of the command to disable the administrative
mode for OSPF.
Syntax
enable
no enable
Default Configuration
Enabled is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
2CSNXXX_SWUM200.book Page 1222 Tuesday, December 10, 2013 1:22 PM