CLI Reference Guide

1212 OSPF Commands
area virtual-link retransmit-interval
Use the area virtual-link retransmit-interval command in Router OSPF
Configuration mode to configure the retransmit interval for the OSPF virtual
interface on the virtual interface identified by the area ID and neighbor ID.
Use the no form of the command to return the retransmit interval to the
default value.
Syntax
area area-id virtual-link neighbor-id retransmit-interval seconds
no area area-id virtual-link neighbor-id retransmit-interval
• area-id — Identifies the OSPF area to configure. (Range: IP address or
decimal from 0–4294967295)
•
neighbor-id — Identifies the Router ID of the neighbor.
•
seconds — The number of seconds to wait between retransmitting LSAs if
no acknowledgement is received. (Range: 0–3600)
Default Configuration
The default configuration is 5 seconds.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a 500-second retransmit wait interval.
console(config-router)#area 10 virtual-link 192.168.2.2 retransmit-interval
500
2CSNXXX_SWUM200.book Page 1212 Tuesday, December 10, 2013 1:22 PM