CLI Reference Guide

OSPF Commands 1207
Syntax
area area-id virtual-link router-id [authentication [message-digest | null]]
[hello-interval
seconds ] [retransmit-interval seconds ] [transmit-delay
seconds ] [dead-interval seconds ] [[authentication-key key ] | [message-
digest-key
key-id md5 key ]]
no area
area-id virtual-link router-id [authentication [message-digest | null]]
[hello-interval] [retransmit-interval] [transmit-delay] [dead-interval]
[[authentication-key] | [message-digest-key]]
• area-id —Identifies the OSPF stub area to configure. (Range: IP address or
decimal from 0-4294967295)
•
router-id —Valid IP address.
•
authentication —Specifies authentication type.
•
message-digest —Specifies that message-digest authentication is used.
•
null —No authentication is used. Overrides password or message-digest
authentication if configured for the area.
•
hello-interval seconds —Number of seconds to wait before sending hello
packets to the OSPF virtual interface. (Range: 1–65535)
•
dead-interval seconds —Number of seconds to wait before the OSPF
virtual interface on the virtual interface is assumed to be dead. (Range:
1–65535)
•
retransmit-interval seconds —The number of seconds to wait between
retransmitting LSAs if no acknowledgement is received. (Range: 0–3600)
•
transmit-delay seconds —Number of seconds to increment the age of the
LSA before sending, based on the estimated time it takes to transmit from
the interface. (Range: 0–3600)
•
md5 —Use MD5 Encryption for an OSPF Virtual Link.
•
key —Authentication key for the specified interface. (Range: 8 bytes or less
if the authentication type is simple and 16 bytes or less if the type is
encrypt.)
•
key-id —Authentication key identifier for the authentication type encrypt.
(Range: 0–255)
2CSNXXX_SWUM200.book Page 1207 Tuesday, December 10, 2013 1:22 PM