CLI Reference Guide

IPv6 Routing Commands 1129
show ipv6 vlan
Use the show ipv6 vlan command in Privileged EXEC mode to display IPv6
VLAN routing interface addresses.
Syntax
show ipv6 vlan
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays IPv6 VLAN routing interface addresses.
console#show ipv6 vlan
MAC Address used by Routing VLANs: 00:02:BC:00:30:68
VLAN ID IPv6 Address/Prefix Length
------- ---------------------------------------
1
traceroute ipv6
Use the traceroute ipv6 command in Privileged EXEC mode to determine
the path and measure the transit delay to another device in the network. The
transit delays are measured for each hop in the network.
Syntax
traceroute ipv6 {ipv6-address|hostname} [count 1-10 ] [init-ttl 1-255 ]
[interval
1-60 ] [max-fail 0-255 ] [max-ttl 1-255 ] [port 1-65535 ] [size 0-
39936
] [source { ipv6-address | loopback 0-7 | vlan 1-4093 }]
• ipv6-address | hostname—The target IP address or host to ping.
2CSNXXX_SWUM200.book Page 1129 Tuesday, December 10, 2013 1:22 PM