CLI Reference Guide

IPv6 Routing Commands 1123
Example
console#show ipv6 mld traffic
Valid MLD Packets Received..................... 52
Valid MLD Packets Sent......................... 7
Queries Received............................... 0
Queries Sent................................... 7
Reports Received............................... 52
Reports Sent................................... 0
Leaves Received................................ 0
Leaves Sent.................................... 0
show ipv6 neighbors
Use the show ipv6 neighbors command in Privileged EXEC mode to display
information about the IPv6 neighbors.
Syntax
show ipv6 neighbors
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC modes, Configuration mode and all
Configuration submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays information about the IPv6 neighbors.
console(config)#show ipv6 neighbors
Bad Checksum MLD
Packets
The number of bad checksum MLD packets received by
the router.
Malformed MLD Packets The number of malformed MLD packets received by the
router.
2CSNXXX_SWUM200.book Page 1123 Tuesday, December 10, 2013 1:22 PM