CLI Reference Guide

IPv6 Routing Commands 1109
Oper.
Interface Mode IPv6 Address/Length
---------- -------- ---------------------------------
Vl3 Enabled FE80::211:88FF:FE2A:3E3C/128
2033::211:88FF:FE2A:3E3C/64
Vl5 Enabled FE80::211:88FF:FE2A:3E3C/128
2017::A42A:26DB:1049:43DD/128 [DHCP]
Vl7 Enabled FE80::211:88FF:FE2A:3E3C/128
2001::211:88FF:FE2A:3E3C/64 [AUTO]
Vl9 Disabled FE80::211:88FF:FE2A:3E3C/128 [TENT]
The Method column shows one of the following values:
Auto – The IPv6 address was automatically generated using IPv6 auto
address configuration (RFC 2462)
Config – The IPv6 address was manually configured.
DHCP – The IPv6 address was leased from a DHCP server.
TENT – Tentative address.
The following example displays the long form of the command, and indicates
whether address autoconfiguration or DHCP client are enabled on the
interface. When the interface acts as a host interface, the output also shows
the default gateway on the interface, if one exists.
console#show ipv6 interface vlan2
IPv6 is enabled
IPv6 Prefix is ................................ FE80::211:88FF:FE2A:3E3C/128
2017::A42A:26DB:1049:43DD/128
[DHCP]
Routing Mode................................... Enabled
Administrative Mode............................ Enabled
IPv6 Routing Operational Mode.................. Enabled
Bandwidth...................................... 100000 kbps
Interface Maximum Transmit Unit................ 1500
Router Duplicate Address Detection Transmits... 1
Address Autoconfigure Mode..................... Disabled
Address DHCP Mode.............................. Enabled
Router Advertisement NS Interval............... 0
Router Advertisement Lifetime.................. 1800
Router Advertisement Reachable Time............ 0
Router Advertisement Interval.................. 600
Router Advertisement Managed Config Flag....... Disabled
Router Advertisement Other Config Flag......... Disabled
Router Advertisement Router Preference......... medium
Router Advertisement Suppress Flag............. Disabled
2CSNXXX_SWUM200.book Page 1109 Tuesday, December 10, 2013 1:22 PM