CLI Reference Guide

IPv6 Routing Commands 1087
User Guidelines
This command has no user guidelines.
Example
console(config)#ipv6 host Dell 2001:DB8::/32
ipv6 mld last-member-query-count
The ipv6 mld last-member-query-count command sets the number of
listener-specific queries sent before the router assumes that there are no local
members on the interface. Use the “no” form of this command to set the last
member query count to the default.
Syntax
ipv6 mld last-member-query-count last-member-query-count
no ipv6 mld last-member-query-count
• last-member-query-count — Query count (Range: 1–20).
Default Configuration
The default last member query count is 2.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld last-member-query-count 5
2CSNXXX_SWUM200.book Page 1087 Tuesday, December 10, 2013 1:22 PM