CLI Reference Guide

Command Groups 108
LLDP
link-dependency group Enters the link-dependency mode to configure
a link-dependency group.
GC
add Adds member gigabit Ethernet port(s) to the
dependency list.
LD
depends-on Adds the dependent Ethernet ports or port
channels list.
LD
show link-dependency Shows the link dependencies configured on a
particular group.
PE
a. For the meaning of each Mode abbreviation, see Mode Types on page 87.
Command Description Mode
a
clear lldp remote-data Deletes all data from the remote data table. PE
clear lldp statistics Resets all LLDP statistics. PE
lldp med Enables/disables LLDP-MED on an interface. IC
lldp med confignotification Enables sending the topology change
notification.
IC
lldp med
faststartrepeatcount
Sets the value of the fast start repeat count. GC
lldp med transmit-tlv Specifies which optional TLVs in the LLDP
MED set are transmitted in the LLDPDUs.
IC
lldp notification Enables remote data change notifications. IC
lldp notification-interval Limits how frequently remote data change
notifications are sent.
GC
lldp receive Enables the LLDP receive capability. IC
lldp timers Sets the timing parameters for local data
transmission on ports enabled for LLDP.
GC
lldp transmit Enables the LLDP advertise capability. IC
lldp transmit-mgmt Specifies that transmission of the local system
management address information in the
LLDPDUs is included.
IC
Command Description Mode
a
2CSNXXX_SWUM200.book Page 108 Tuesday, December 10, 2013 1:22 PM