CLI Reference Guide

1074 IP Routing Commands
RIP Routes..................................... 0
OSPF Routes.................................... 0
Intra Area Routes.............................. 0
Inter Area Routes.............................. 0
External Type-1 Routes......................... 0
External Type-2 Routes......................... 0
Total routes................................... 0
show ip traffic
Use the show ip traffic command in User EXEC mode to display IP statistical
information of the software IP stack. Refer to RFC 1213 for more information
about the fields that are displayed.
Syntax
show ip traffic
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC modes, Configuration mode and all
Configuration submodes
User Guidelines
This command displays statistics for the software IP stack, not the hardware
routing information.
Example
The following example displays IP route preferences.
console>show ip traffic
IpInReceives................................... 24002
IpInHdrErrors.................................. 1
IpInAddrErrors................................. 925
IpForwDatagrams................................ 0
IpInUnknownProtos.............................. 0
IpInDiscards................................... 0
IpInDelivers................................... 18467
IpOutRequests.................................. 295
2CSNXXX_SWUM200.book Page 1074 Tuesday, December 10, 2013 1:22 PM