CLI Reference Guide

1058 IP Routing Commands
Actions in the MAC ACL configuration are applied with other actions
configured in the route map. When a MAC ACL referenced by a route map is
removed, the route map rule is also removed.
Example
console(config-route-map)#match mac-list mac-test
route-map
Use this command to create a policy based route map. Use the no form of this
command to delete a route map or one of its statements.
Syntax
route-map map-tag [permit | deny] [ sequence-number ]
no route-map
map-tag [permit | deny] [ sequence-number ]
• map-tag — Text name of the route map. Route maps with the same name are
grouped together in order of their sequence numbers. A route map name may be
up to 32 characters long and comprised of any printable character. Enclose the
map-tag in quotes to embed blanks in the name.
• permit — (Optional) Permit routes that match all of the match conditions in the
route map.
• deny — (Optional) Deny routes that match all of the match conditions in the
route map. Packets matching deny routes use the routing table.
• sequence-number — (Optional) An integer used to order the set of route maps.
Route maps are ordered from lowest to greatest sequence number, with lower
sequence numbers being considered first. If no sequence number is specified,
the system assigns a value ten greater than the last statement in the route map.
The range is 0 to 65,535.
Default Configuration
No route maps are configured by default. If no permit or deny tag is specified,
permit is the default.
Command Mode
Global Configuration mode
2CSNXXX_SWUM200.book Page 1058 Tuesday, December 10, 2013 1:22 PM