CLI Reference Guide

1042 IP Helper/DHCP Relay Commands
Example
show ip helper-address
IP helper is enabled
Interface UDP Port Discard Hit Count Server Address
--------------- ----------- -------- ---------- ---------------
vlan 100 dhcp No 10 10.100.1.254
10.100.2.254
vlan 101 any Yes 2
any dhcp No 0 10.200.1.254
show ip dhcp relay
Use the show ip dhcp relay command in User EXEC mode to display the
BootP/DHCP Relay information.
Syntax
show ip dhcp relay
Default Configuration
The command has no default configuration.
Command Mode
User EXEC and Privileged EXEC modes, Configuration mode and all
Configuration submodes
User Guidelines
This command has no user guidelines.
Example
The following example defines the Boot/DHCP Relay information.
console#show ip dhcp relay
Maximum Hop Count.............................. 4
Minimum Wait Time(Seconds)..................... 0
Circuit Id Option Mode....................... Disable
Circuit Id Option Check Mode................. Enable
2CSNXXX_SWUM200.book Page 1042 Tuesday, December 10, 2013 1:22 PM