CLI Reference Guide

1024 IGMP Proxy Commands
Example
The following example sets 10 seconds as the unsolicited report interval for
the IGMP Proxy router.
console(config)#interface vlan 15
console(config-if-vlan15)#ip igmp proxy-service unsolicit-rpt-interval 10
show ip igmp proxy-service
Use the show ip igmp proxy-service command in Privileged EXEC mode to
display a summary of the host interface status parameters. It displays status
parameters only when IGMP Proxy is enabled.
Syntax
show ip igmp proxy-service
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC mode, Configuration mode and all
Configuration submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays a summary of the host interface status
parameters.
console#show ip igmp proxy-service
Interface Index............................... vlan13
Admin Mode.................................... Enable
Operational Mode.............................. Enable
Version....................................... 3
Number of Multicast Groups.................... 0
Unsolicited Report Interval................... 1
Querier IP Address on Proxy Interface......... 0.0.0.0
Older Version 1 Querier Timeout............... 0
Older Version 2 Querier Timeout............... 0
2CSNXXX_SWUM200.book Page 1024 Tuesday, December 10, 2013 1:22 PM