CLI Reference Guide

IGMP Commands 1017
show ip igmp groups
Use the show ip igmp groups command in User EXEC or Privileged EXEC
modes to display the registered multicast groups on the interface. If detail is
specified, this command displays the registered multicast groups on the
interface in detail.
Syntax
show ip igmp groups [ interface-type interface-number ] [detail]
• interface-type interface-number —Interface type of VLAN and a valid VLAN
ID
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC modes, Configuration mode and all
Configuration submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays the registered multicast groups for VLAN 1.
console#show ip igmp groups interface vlan 3 detail
REGISTERED MULTICAST GROUP DETAILS
Version1 Version2 Group
Multicast Last Up Expiry Host Host Compat
IP Address Reporter Time Time Timer Timer Mode
--------------- ------------ ---------- --------- ------- -------- -----
225.0.0.5 1.1.1.5 00:00:05 00:04:15 ------ 00:04:15 v2
show ip igmp interface
Use the show ip igmp interface command in Privileged EXEC mode to
display the IGMP information for the specified interface.
2CSNXXX_SWUM200.book Page 1017 Tuesday, December 10, 2013 1:22 PM