CLI Reference Guide

IGMP Commands 1009
ip igmp last-member-query-count
Use the ip igmp last-member-query-count command in Interface
Configuration mode to set the number of Group-Specific Queries sent before
the router assumes that there are no local members on the interface.
Syntax
ip igmp last-member-query-count Imqc
no ip igmp last-member-query-count
• Imqc — Query count. (Range: 1-20)
Default Configuration
The default last member query count is 2.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets 10 as the number of VLAN 2 Group-Specific
Queries.
console#configure
console(config)#interface vlan 2
console(config-if-vlan2)#ip igmp last-member-query-count 10
console(config-if-vlan2)#no ip igmp last-member-query-count
ip igmp last-member-query-interval
Use the ip igmp last-member-query-interval command in Interface
Configuration mode to configure the Maximum Response Time inserted in
Group-Specific Queries which are sent in response to Leave Group messages.
Syntax
ip igmp last-member-query-interval tenthsofseconds
2CSNXXX_SWUM200.book Page 1009 Tuesday, December 10, 2013 1:22 PM