Practices Guide

LC Integration Best Practices Specification

Note the value of the RaidStatus parameter of the desired physical disk.

D) ConvertToNonRAID(): Invoke this method

E) CreateRAIDConfigJob(): Apply step D) [ReturnValue=4096]

F) Poll jobstatus for Completed: GET the InstanceID of from E). See section 2.3 for a

definition of GET.

G) The Lifecycle Controller remote service must be in a “ready” state before executing any

other WSMAN commands.

GetRemoteServicesAPIStatus()

H) GetPhysicalDiskViews(): ENUMERATE the DCIM_PhysicalDiskView class to view all

available physical disk FQDDs. See section 2.2 for a definition of ENUMERATE .

Note the new value of the RaidStatus parameter of the desired physical disk.

15 Record Log Profile Use Cases

15.1 Discovery of Record Log profile support

Use the following procedure below to confirm the existence of Record Log profile support.

Applies to: LC1.5.0+

Prerequisites for script: none

Script: GetRecordLogProfile.win

A) The Lifecycle Controller remote service must be in a “ready” state before executing any

other WSMAN commands. The GetRSStatus() method or the GetRemoteServicesAPIStatus()

method may be used depending on the version of the LC Management registered profile.

B) GetLCRegisteredProfiles(): ENUMERATE the DCIM_LCRegisteredProfile class to view all

registered profiles. See section 2.2 for a definition of ENUMERATE .

C) Search for “RegisteredName=Record log” and note its instanceID to use in step D)

D) GetLCRegisteredProfile(): GET the DCIM_LCRegisteredProfile instance using the

InstanceID from C). See Section 2.3 for a definition of GET.

Results for the InstanceID of DCIM:RecordLog:1.0.0 shown below. If no instance is returned, the

profile is not supported.

DCIM_LCRegisteredProfile

AdvertiseTypeDescriptions = WS-Identify

AdvertiseTypeDescriptions = Interop Namespace

AdvertiseTypes = 1