Practices Guide

LC Integration Best Practices Specification

GetRemoteServicesAPIStatus():

B) GetLCRegisteredProfiles(): ENUMERATE the DCIM_LCRegisteredProfile class to view all

registered profiles. See section 2.2 for a definition of ENUMERATE .

C) Search for “RegisteredName=Profile Registration” and note its instanceID to use in step D)

D) GetLCRegisteredProfile(): GET the DCIM_LCRegisteredProfile instance using the

InstanceID from C). See Section 2.3 for a definition of GET.

Results for the InstanceID of DCIM:ProfileRegistrationProfile shown below. If no instance is

returned, the profile is not supported.

DCIM_LCRegisteredProfile

AdvertiseTypeDescriptions = WS-Identify

AdvertiseTypeDescriptions = Interop Namespace

AdvertiseTypes = 1

InstanceID = DCIM:ProfileRegistrationProfile

OtherRegisteredOrganization = DCIM

ProfileRequireLicense

ProfileRequireLicenseStatus

RegisteredName = Profile Registration

RegisteredOrganization = 1

RegisteredVersion = 1.0.0

14 Simple RAID Profile Use Cases

14.1 Discovery of RAID profile support

Use the following procedure below to confirm the existence of RAID profile support.

Applies to: LC1.5.0+

Prerequisites for script: none

Script: GetRAIDProfile.win

A) The Lifecycle Controller remote service must be in a “ready” state before executing any

other WSMAN commands. The GetRSStatus() method or the GetRemoteServicesAPIStatus()

method may be used depending on the version of the LC Management registered profile.

B) GetLCRegisteredProfiles(): ENUMERATE the DCIM_LCRegisteredProfile class to view all

registered profiles. See section 2.2 for a definition of ENUMERATE .

C) Search for “RegisteredName=Simple RAID” and note its instanceID to use in step D)

D) GetLCRegisteredProfile(): GET the DCIM_LCRegisteredProfile instance using the

InstanceID from C). See Section 2.3 for a definition of GET.