Practices Guide

LC Integration Best Practices Specification

Applies to: LC2+

Prerequisites for script: Set variables by editing script

Script: SetEventFilterByInstanceIDs.win

A) The Lifecycle Controller remote service must be in a “ready” state before executing any

other WSMAN commands.

GetRemoteServicesAPIStatus():

B) GetEventFilters(): ENUMERATE the DCIM_EventFilter class to view all available instances

to use in C). See section 2.2 for a definition of ENUMERATE .

C) SetEventFilterByInstanceIDs(): Sets the action and notifications for the event filters

9 iDRAC Card Profile Use Cases

9.1 Discovery of iDRAC Card profile support

Use the following procedure below to confirm the existence of iDRAC Card profile support.

Applies to: LC1.5.0+

Prerequisites for script: none

Script: GetiDRACCardProfile.win

A) The Lifecycle Controller remote service must be in a “ready” state before executing any

other WSMAN commands. The GetRSStatus() method or the GetRemoteServicesAPIStatus()

method may be used depending on the version of the LC Management registered profile.

B) GetLCRegisteredProfiles(): ENUMERATE the DCIM_LCRegisteredProfile class to view all

registered profiles. See section 2.2 for a definition of ENUMERATE .

C) Search for “RegisteredName=iDRAC Card” and note its instanceID to use in step D)

D) GetLCRegisteredProfile(): GET the DCIM_LCRegisteredProfile instance using the

InstanceID from C). See Section 2.3 for a definition of GET.

Results for the InstanceID of DCIM:iDRACCard:1.0.0 shown below. If no instance is returned, the

profile is not supported.

DCIM_LCRegisteredProfile

AdvertiseTypeDescriptions = WS-Identify

AdvertiseTypeDescriptions = Interop Namespace

AdvertiseTypes = 1

InstanceID = DCIM:iDRACCard:1.0.0

OtherRegisteredOrganization = DCIM

ProfileRequireLicense = Remote Firmware Configuration